3 Series E36 Z3 (M52TU) ROADST
Press nipple out of nipple mounts.
Take Bowden cable out of nipple mounts.
Remove protective cap using a screwdriver.
Pull out Bowden cable towards rear of vehicle.
Take rubber pad out of retainer.
Installation:
Guide in Bowden cable as far as stop.
Overview of throttle cable to throttle-valve assembly:
1 Nipple
2 Accelerator Bowden cable
3 Protective cap
4 Rubber mount
5 Sleeve
6 Adjusting screw
Engine M52:
Press nipple (1) of Bowden cable out of nipple mount.
Pull Bowden cable out of rubber mount (2) and detach rubber
mount from bracket.
Installation:
Firt engage rubber mount (2) in bracket and then press
Bowden cable into rubber mount.
RA Replacing Bowden cable for throttle valve actuation
BMW AG - TIS
11.02.2013 06:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
