3 Series E36 Z3 (M52TU) ROADST
Old build status:
Drive rivet out in upwards direction.
Pull off rubber grommet.
New build status:
To brace a socket nut (1) (e.g. size 10 mm), mask with fabric
adhesive tape (damage to paintwork) and use hammer (500
grammes).
Drive rivet (2) upwards to remove.
New build status:
Installation:
Insert lug (1) in bore. Fit tab (2) on rivet (3) facing door. Pull
off fabric adhesive tape (4).
Unfasten screws.
Push retarder upwards into door and remove.
RA Removing and installing or replacing door stop on left or right front door
BMW AG - TIS
11.02.2013 08:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
