3 Series E36 Z3 (M52TU) ROADST
63 12 001
Removing and installing/replacing entire left
headlight (Z3 roadster, Z3 coupé)
Remove suction-filter housing and air-mass sensor,
refer to Group 13
Disconnect all plug connectors.
Twist lamp socket and pry out.
Caution!
Brace expanding rivets when unfastening the screws. The
headlight is adapted to suit the body using the expanding
rivets.
When installing a headlight, first screw in lower screws as far as
last thread, at the same time bracing the expanding rivets.
Check gap (C and D) between bumper and headlight. If
necessary, twist the lower expanding rivets to adjust gap (D) to
approx. 5 mm. Adjust gap (C) in lower range to approx. 5 mm by
moving the headlight to one side. The gap (C) narrows towards
the top to approx. 2.5 mm. Then tighten screws while
counterholding expanding rivets.
RA Removing and installing/replacing entire left headlight (Z3 roadster, Z3 coupé)
BMW AG - TIS
11.02.2013 10:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
