3 Series E36 Z3 (M54) ROADST
Press bearing (2) off countershaft with a special tool 23 1 250
on a hydraulic press.
Press inner bearing race (3) off countershaft with special tool
00 7 500 / 23 1 250 on a hydraulic press.
Note:
Taper (2) on outer bearing race must point upwards.
Press new bearing (1) off countershaft with special tool 23 1 040
on a hydraulic press.
Clamp countershaft in a vise with protective jaws.
Screw in new Torx screw (1) and tighten down.
Tightening Torque,
refer to Technical Data 23 11 10AZ.
RA Replacing bearings on all gearshafts (S5D 200G/ 250G)
BMW AG - TIS
11.02.2013 03:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -