3 Series E36 Z3 (M54) ROADST
36 10 008
Electronic balancing of left or right front
wheel (finish balancer)
Always balance wheels in a stationary state prior to electronic
balancing,
refer to 36 10 508
Caution!
Balancing should always be carried out on a solid surface
(concrete floor without basement).
Also refer to Service Information, Gr. 36.
If the displayed value for finish-balancing is more than 15
grammes on one wheel, the possible causes (e.g. inaccurate
stationary balancing, wheel centering, etc.) - also refer to Service
Information 36 04 83 (196) - must be eliminated before finish-
balancing is completed and the previously finish-balanced wheel
must be rechecked.
Apply balancing gauge on control arm.
Position of application:
Outside of control arm on narrow cross section, approx. 50 mm
away from ball joint.
Use a suitable take-up pivot or additional pivot (refer to Service
Information or Workshop Equipment).
Caution!
Vehicle must not be loaded!
Lower car slowly.
Do not let it fall on control arm.
Otherwise wheel suspension could be damaged.
RA Electronic balancing of left or right front wheel (finish balancer)
BMW AG - TIS
11.02.2013 07:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
