3 Series E46 316Ci (N45) COUPE
Note:
The height of the cylinder head can only be determined by means
of measurement (A).
Bore (1) is on the cylinder head at the front on the exhaust side.
Measurement (A) is the gap between bore center (1) and
cylinder head lower face.
Check measurement (A) before machining the cylinder head.
Original measurement (A): 10 mm
Machining limit measurement (A): 9.7 mm
Note:
A cylinder head seal 0.3 mm thicker than usual can be obtained
for machined (milled) cylinder heads.
RA Grinding cylinder head lower face (N40 / N45)
BMW AG - TIS
18.01.2013 19:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
