3 Series E46 316Ci (N45) COUPE
12 61 285
Replacing engine oil level sensor
Necessary preliminary tasks:
•
Switch off ignition
•
Unfasten oil filter cap to enable engine oil in filter to flow back
into the oil sump
•
E87, E60, E90: Remove underbody protection
•
E46, E60: Remove reinforcement plate
•
Drain off engine oil
Disconnect plug connection (1).
Unscrew nuts (2).
Remove oil level sensor (3).
Installation:
Clean sealing face on oil sump.
Replace seal on oil level sensor.
Installation:
Top up engine oil.
Screw on oil-filter cover tightly.
Tightening torque 11 42 2AZ
.
RA Replacing engine oil level sensor
BMW AG - TIS
18.01.2013 19:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
