3 Series E46 316Ci (N45) COUPE
The two bores (1) for securing the ITS head airbag gas generator
from 07 / 99 are seated in the direct vicinity of the welding spots
for the bracket for the instrument panel trim (2).
After drilling the two bores (1) for securing the ITS head airbag
gas generator from 07 / 99, it is absolutely essential to check the
strength of the welding spots for the bracket for the instrument
panel trim (2); if necessary, reweld or reset the welding spots.
Note:
If a gas generator of the version up to 07 / 98 is replaced by a gas
generator of the version from 07 / 99, it is necessary to make
further modifications.
The plug for the ITS head airbag gas generator has been changed
and the cable length must be extended by approx. 250 mm to
accommodate the altered gas generator.
Procedure for extending airbag cables is the same as the
procedure for cable repairs:
If wiring harness is visibly damaged,
refer to 72 12 ... Repairing airbag cables
Release retaining screw, A-pillar.
Note:
Screw is held in end fitting by locking washer.
Installation:
Tightening torque,
refer to Technical Data 72 12 4AZ
View of mounting bolt on A-pillar with end fitting of ITS head
airbag
1.
End fitting of ITS head airbag
2.
Lock washer
3.
Mounting bolt on A-pillar
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
19.01.2013 01:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
