bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 SI Oil Level Warning Lamp Malfunction E46 M43TU|Page 55 > < 1 SI Master Document For Emissions Test Nominal Values All Series Up To 2003
Page 1
background image

VS-21/Lausmann

Baugruppe/Group: 12

12 01 99 (437)

weltweit 
all countries 
ohne
USA/Kanada

09/1999

Oil level warning lamp malfunction

E46 / M43TU

Complaint: 

The yellow engine oil level warning lamp lights up even though the oil level 
is OK.

Cause: 

Increased contact resistance at the plug connector between the engine wiring harness and
the oil level sensor, caused by ingress of moisture and corrosion at the contacts.

Affected
vehicles:

E46/4 with M43B19/87 kW 
Manufacturing period: start of series production to June 1998

Remedy: 

Visual inspection of contacts on the plug connector between the oil level sensor and the
engine wiring harness. If traces of moisture or corrosion are detected, replace the oil level
sensor and the connector .

Note:

Check whether the vehicle was affected by Technical Campaign 
SI 00122601/1098 (retrofit cable ties) and whether this campaign was 
carried out on the vehicle concerned. If this is not the case despite an earlier
customer notification, warranty rights are invalidated!

Procedure:

As per work instructions "Repairing a plug connector on the wiring harness using butt
connectors", 

see also Repair Instructions 61 13.

-

Remove the front underbody protection.

-

Pull off the connector from the oil level sensor

-

Unfasten the cable clip from the retaining plate for the fuel hoses and remove from the
cable

-

Cut off the cable just behind the rubber grommet, pull off the protective hose

-

Cut the wires to length to match the repair kit (grey/blue 20 mm, 
black 40 mm) and strip

-

Slide on a 140 mm insulator hose and shrink-fit hoses

-

Carefully crimp the butt connectors, seal with shrink-fit hoses and slide on insulator
hose

-

Plug the cable holder provided to the cast rib on the crankcase below the starter motor
(see illustration)

-

Press the cable clip into the retainer plate for fuel hoses

-

Loop off excess cable length and secure in the cable holder on the crankcase (see
illustration)

SI  Oil level warning lamp malfunction E46 M43TU

BMW AG - TIS

19.01.2013  09:19

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 SI Oil Level Warning Lamp Malfunction E46 M43TU|Page 55 > < 1 SI Master Document For Emissions Test Nominal Values All Series Up To 2003