3 Series E46 316i (N40) SAL
Installation:
Replace sealing ring (2) on suction tube (1).
N40/N42:
Note:
The special tool bore for the TDC position is located on the inlet
side underneath the starter motor.
Rotate engine at central bolt and secure flywheel in position with
special tool 11 9 190 .
N45/N46:
Note:
The special tool bore for the TDC position is located on the inlet
side underneath the starter motor.
Crank engine at central bolt and secure flywheel with special tool
11 5 120 .
Automatic transmission only
Illustration does not show automatic transmission.
Important!
On engines with automatic transmissions, there is shortly
before the special tool bore (1) for the TDC position a large
bore (2) which can be confused with the special tool bore.
If the flywheel is secured in the correct bore (1) with the special
tool 11 9 190, the engine can no longer be moved at the
central bolt.
RA Removing and installing/replacing oil pump (N40/N42/N45/N46)
BMW AG - TIS
20.01.2013 03:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -