3 Series E46 316i (N40) SAL
32 41 060
Removing and installing/replacing power
steering vane pump (N4x)
Important!
Follow instructions for working on cooling system!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off coolant hoses and hydraulic lines with plugs.
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Remove front assembly underside protection
•
Drain and dispose of coolant from radiator
•
Disconnect coolant hoses from thermostat housing and
thermostat
•
Remove belt pulley
Unfasten hose clip (2).
Detach suction line (1) from vane pump.
Release banjo bolt (3).
Disconnect pressure line (4).
Installation:
Replace sealing rings (D).
Tightening torque 32 41 3AZ
.
Slacken bolts (1)
Tightening torque 32 41 20AZ
.
If necessary, disconnect plug connection (2).
Release screw (3) and lay connecting line (4) with bracket to
one side.
Tightening torque 32 41 1AZ
.
Release screws (5).
Tightening torque 32 41 1AZ
.
Remove vane pump with water pump and set down on front axle
carrier.
RA Removing and installing/replacing power steering vane pump (N4x)
BMW AG - TIS
20.01.2013 05:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -