3 Series E46 316i (N40) SAL
Weld connection point, cover for inside side member/outer wheel
arch section.
Grind welding spots until smooth.
Make C-pillar reinforcement spare part.
If necessary, drill out sunroof water drainage pipe.
Determine and mark out side panel reinforcement cutting line.
Measurement (A) = measured from center of bore dia. 12 mm.
Note:
Note relief measurement.
Measurement (A) = 50 mm - relief measurement.
Cut and relieve side panel reinforcement spare part.
RA Replacing outer section of left or right rear wheel housing (side panel removed)
BMW AG - TIS
20.01.2013 06:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -