3 Series E46 316i (N42) SAL
Note:
A cylinder head seal 0.3 mm thicker than usual can be obtained
for machined (milled) cylinder heads.
Important!
There must be no oil in the tapped holes of the engine block.
Risk of cracking and distorted tightening values.
Replace cylinder head gasket.
Put the cylinder head on.
Fit new cylinder head screws.
Apply a light coat of oil to washer contact area and thread of new
cylinder head bolts.
Note:
Cylinder head bolts 1 to 6 have an M10 thread with an
E12 bolt head.
Cylinder head bolts 7 to 10 have an M8 thread with an
E10 bolt head. Cylinder head bolt 10 is shorter than the others.
Because of the unfavorable position of the exhaust camshaft,
cylinder head bolt 10 is only accessible with an E10 socket with
1/4" drive.
Tighten down cylinder head bolts in sequence 1 to 10.
Tightening torque 11 12 6AZ .
Insert screws (1) and tighten down screw connection between
engine block and cylinder head.
RA Removing and installing/sealing cylinder head (N42)
BMW AG - TIS
20.01.2013 18:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
