3 Series E46 316i (N42) SAL
Note:
Lubricate eccentric shaft at bearing positions.
Replace needle bearing (1).
Important!
Needle bearings break off very easily when installed.
Carefully press needle bearings (1) apart at split position only to
such an extent that they can be fitted over eccentric shaft.
Insert eccentric shaft (1).
Note:
Bearing caps of eccentric shaft are marked E1 to E4 from inlet
side.
Lubricate bearing shells of bearing caps.
Fit bearing caps of eccentric shaft.
Insert nuts of bearing caps 1 and 3 and tighten without play.
RA Removing and installing / replacing eccentric shaft (N42 / N46)
BMW AG - TIS
20.01.2013 19:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
