3 Series E46 316i (N42) SAL
Open screw plug (1).
Installation:
Replace seal.
Tightening torque: 25 Nm.
Release screw (2).
Important!
CCW thread!
Release nut (1) on oil pump sprocket wheel.
Installation:
Tightening torque 11 41 4AZ .
Push clamping rail (4) towards rear and secure with special tool
11 3 340 .
Release screw connection (3) of guide rail to oil pump.
Note:
Chain tensioner (1) is secured with a pin (2).
Detach chain tensioner (1) from locking pin (2).
RA Removing and installing/replacing chain tensioner for oil pump drive (N40/N42/N4
BMW AG - TIS
20.01.2013 19:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
