3 Series E46 316i (N42) SAL
Installation:
Sheet metal flywheel is provided with three recesses for
retaining lugs of torque converter.
When joining up the engine and transmission, the three
mounting tabs on the torque converter must be aligned with
the three indentations in the sheet metal flywheel.
Non-conformance leads to follow-up damage on the
automatic transmission.
Turning on the torque converter, or engine, is no longer
possible after guiding the engine and transmission together
and would lead to damage.
Installation:
Bore on driver must point to center of aperture in cover plate.
Installation:
Twist torque converter on transmission until bores on lugs
point to center of bore on flywheel.
Screw special tool 24 2 300 into lug.
Installation:
Lift automatic transmission until bore in drive plate is reached.
Carefully insert transmission into bore on driver with special
tool 24 2 300 .
Bolt transmission housing to engine.
Remove special tool 24 2 300 from lug towards front.
RA Removing and installing automatic transmission (A5S 360/390R, N42/N46)
BMW AG - TIS
20.01.2013 20:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -