3 Series E46 316i (N45) SAL
11 12 000
Removing and installing/sealing cylinder head
cover (N40 / N45)
Necessary preliminary tasks:
•
Remove heater bulkhead.
•
Remove ignition coil cover.
•
Remove ignition coils.
Removal of cylinder head is described separately from installation.
Removal:
Unscrew nuts.
Unlock and detach vent hose (1).
Unclip cable (2).
Unclip cable duct (3) and place to one side.
Release screws (1 and 2).
Remove cylinder head cover (3).
Installation of cylinder head is described separately from removal.
Installation:
Note:
The cylinder head cover and the gasket of the cylinder head cover
are made from one material which adapts itself to the contour of
the cylinder head.
The gasket and the uncoupling elements of the screw connection
are matched to each other.
RA Removing and installing/sealing cylinder head cover (N40 / N45)
BMW AG - TIS
22.01.2013 07:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
