3 Series E46 316i (N45) SAL
Note:
The special tool bore for the TDC position is located on the inlet
side underneath the starter motor.
For improved accessibility: unclip cable in area of special tool bore
and press to one side.
Secure engine with special tool 11 9 190 in firing TDC position
of 1st cylinder.
Automatic transmission only
Illustration does not show automatic transmission.
Important!
On engines with automatic transmissions, there is shortly
before the special tool bore (1) for the TDC position a large
bore (2) which can be confused with the special tool bore.
If the flywheel is secured in the correct bore (1) with the special
tool 11 9 190 , the engine can no longer be moved at the
central bolt.
Slacken screws of exhaust and inlet adjustment unit and then
reinstall without play.
Place special tool 11 7 252 on inlet camshaft and align inlet
camshaft so that special tool 11 7 252 rests without a gap on
cylinder head.
RA Adjusting camshaft timing (N40 / N45)
BMW AG - TIS
22.01.2013 07:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -