3 Series E46 316i (N45) SAL
11 36 046
Removing and installing/replacing inlet and
exhaust adjustment units (N40 / N45)
Special tools required:
•
00 9 250
•
11 7 251
•
11 7 252
•
11 7 253
•
11 7 260
•
11 9 340
Read fault memory and make a documentary record.
Necessary preliminary tasks:
•
Remove cylinder head.
•
Remove all spark plugs.
•
Check camshaft timing.
Important!
When the engine is shut down, the inlet and exhaust
adjustment unit is normally locked in its initial position.
The situation may arise in some individual cases where this
initial position is not reached and the camshaft can continue
to be rotated in the adjustment range of the adjustment unit.
In order to avoid incorrect timing adjustment, it is essential to
check the locking of the adjustment unit and if necessary
perform locking by rotating the camshafts.
RA Removing and installing/replacing inlet and exhaust adjustment units (N40 / N45)
BMW AG - TIS
22.01.2013 07:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -