3 Series E46 316i (N45) SAL
Lever out spring (1) with a screwdriver from lug (2) on housing.
Tilt spring (1) upwards.
Remove bearing pin (1).
Installation:
Grease bearing pin (1).
Grease,
refer to Service Operating Fluids.
Detach cable plug (1) from reverse gear switch.
Detach cables from fixtures on transmission.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ .
Pull out transmission towards rear and remove.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
RA Removing and installing transmission (S5D 200/250G, N42/N45/46)
BMW AG - TIS
22.01.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -