3 Series E46 316i (N46) SAL
Clamp special tool 11 9 320 as illustrated in a vise.
Important!
Do not tilt bearing bracket (1).
Rockers arms (1) are divided into individual tolerance
classes.
Used rocker arms (1) may only be reused in the same
position.
Carefully lift out bearing bracket (1).
Do not remove rocker arms on inlet side.
Deposit bearing bracket with inlet camshaft upwards in special
tool 11 9 320 .
Warning!
Risk of injury and damage possible.
While torsion springs (1) are still installed, knurled screw on
special tool 11 9 301 must not be released.
Only after all the torsion springs (1) have been removed can the
inlet camshaft be safely removed.
RA Removing and installing/replacing inlet camshaft (N42/N46)
BMW AG - TIS
23.01.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -