3 Series E46 316i (N46) SAL
Insert 4 nuts on bearing bracket at front and install without play.
Insert bearing bracket nut on exhaust side and install without play.
Tighten bearing bracket nuts from inside outwards to initial torque
of 5 Nm and then tighten down to 10 Nm.
Remove special tool 11 9 310 from oil line and feed out from
intermediate lever.
Relieve tension on knurled screw (2) on special tool 11 9 301 .
Release screw (1) and remove special tool 11 9 301 .
RA Removing and installing/replacing inlet camshaft (N42/N46)
BMW AG - TIS
23.01.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -