3 Series E46 316i (N46) SAL
Note:
Illustration with engine removed.
Rotate eccentric shaft (1) at hexagon as shown in illustration.
Pretension torsion spring (2) with a cable strap (1) and carefully
fit on roller (3).
Rotate eccentric shaft (1) at hexagon as shown in illustration.
Place special tool 11 9 292 on inlet camshaft and align inlet
camshaft so that special tool 11 9 292 rests without a gap on
cylinder head.
RA Removing and installing/replacing intermediate levers (N42/N46)
BMW AG - TIS
23.01.2013 00:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -