3 Series E46 316ti (N40) COMP
N40 only:
Release nuts.
Release and detach vent hose (1).
Unclip cable (2).
Unclip cable duct (3).
Detach plug connections of wiring harness section for ignition coils
in electronics box. This task is described in the section Replacing
control unit.
Pull off rubber strip from assembly partition wall.
Pull wiring harness section for ignition coils from assembly
partition wall and remove.
Installation:
Make sure gasket of wiring harness section for ignition coils is
correctly positioned in assembly partition.
Note:
Interrogate fault memory of DME control unit.
Check stored fault messages.
Rectify faults.
Then clear fault memory.
RA Replacing wiring harness section for ignition coil (N42 / N40)
BMW AG - TIS
24.01.2013 19:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -