3 Series E46 316ti (N42) COMP
11 66 000
Removing and installing/replacing vacuum
pump (N42/N46)
Note:
Press brake pedal several times to reduce vacuum in brake
booster.
Installation location:
Vacuum pump is located at rear of cylinder head on exhaust
camshaft.
Remove ignition coil cover.
E46 only
Remove heater rear panel.
Note:
For purposes of clarity, this work step is shown on the engine after
it has been removed.
Release screws and remove vacuum pump (1).
Installation:
Replace sealing ring (2).
Drive (1) must be turned into correct position prior to installation.
Note:
For purposes of clarity, this work step is shown without the
cylinder head cover.
Align drive (1) of vacuum pump to groove (2) of exhaust
camshaft.
RA Removing and installing/replacing vacuum pump (N42/N46)
BMW AG - TIS
25.01.2013 14:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
