3 Series E46 316ti (N42) COMP
Warning!
Risk of injury and damage possible.
The following text describes the removal of the bearing bracket
and the inlet camshaft.
Comply with the recommended procedure and use of the special
tools.
It is not possible to remove the bearing bracket and inlet camshaft
without special tools.
Rotate eccentric shaft (1) at hexagon as shown in illustration
back to minimum stroke position.
Fit special tool 11 9 302 as illustrated and screw down with
special tool 11 9 303 in inlet camshaft.
Note:
Special tool 11 9 302 secures inlet camshaft with bearing
bracket (1).
Unscrew knurled screw (2).
Secure special tool 11 9 301 with screw (1) on eccentric shaft.
Align special tool 11 9 301 to inlet camshaft.
Install knurled screw (2) without play.
Tighten screw (1).
Gently pretension knurled screw (2) by hand.
RA Removing and installing/replacing intermediate levers (N42/N46)
BMW AG - TIS
25.01.2013 14:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -