3 Series E46 316ti (N42) COMP
32 31 053
Replacing flexible disc
Necessary preliminary tasks:
•
Move steering wheel to straight-ahead position
•
Remove ignition key.
•
If necessary, remove assembly underside protection
After installation:
•
Carry out steering angle sensor adjustment
Release both clamping screws from flexible disc.
Detach flexible disc from power steering gear.
Detach flexible disc from lower section of steering spindle and
remove.
Installation:
If necessary, move power steering gear to straight-ahead position
- markings on cap (1) and housing (2) must match up.
Replace clamping screws.
Tightening torque 32 31 1AZ
.
RA Replacing flexible disc
BMW AG - TIS
25.01.2013 17:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -