3 Series E46 316ti (N42) COMP
34 52 560
Removing and installing/replacing pressure
sensor "V" for DSC
Note:
Note "General Information",
refer to 34 00 ...
Caution!
After replacing the pressure sensor, carry out a calibration
with DIS (Diagnosis and Information System) under menu
item "Service functions".
After completing work, bleed brake system,
refer to 34 00 050.
Remove heater bulkhead,
refer to 51 71 080.
Remove expansion tank for brake fluid,
refer to 34 31 181.
Remove seal (1) towards top.
Remove vacuum line and B+line from assembly compartment
partition wall.
Turn seals (1) through 90
°
and thus unlock. Remove assembly
compartment partition wall (2) towards top.
Installation:
When installing the vacuum line and B+line, ensure rubber
grommets are correctly seated.
RA Removing and installing/replacing pressure sensor "V" for DSC
BMW AG - TIS
25.01.2013 18:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -