3 Series E46 316ti (N45) COMP
Place special tool 11 7 252 on inlet camshaft and align inlet
camshaft so that special tool 11 7 252 rests without a gap on
cylinder head.
Fit special tool 11 7 251 on exhaust camshaft.
Turn back special tool 11 7 253 .
Hold inlet camshaft with special tool 11 7 251 so that it rests
without a gap on cylinder head.
Insert screws and tighten down special tool 11 7 251 on
cylinder head.
Tighten down special tool 11 7 253 by hand until it is supported
on special tool 11 7 252 .
Insert screw and tighten down special tool 11 7 252 on cylinder
head.
RA Removing and installing/replacing inlet and exhaust adjustment units (N40 / N45)
BMW AG - TIS
26.01.2013 14:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
