3 Series E46 316ti (N45) COMP
11 61 050
Removing and installing intake manifold (N40
/ N45)
Special tools required:
•
11 9 380
Necessary preliminary tasks:
•
Remove microfilter housing.
•
Remove suction filter housing.
•
Remove injection pipe.
Pull off sealing strip (1) towards top.
Turn fasteners (1) through 90
°
and release.
Detach electrical leads with profile seals from assembly
compartment partition wall towards top.
Remove assembly compartment partition wall (2) towards top.
Installation:
Check installation position of profile seal.
RA Removing and installing intake manifold (N40 / N45)
BMW AG - TIS
26.01.2013 14:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
