3 Series E46 316ti (N45) COMP
61 62 060
Removing and installing / replacing rear
window wiper motor
Remove panel for rear lid.
Remove wiper arm for rear wiper.
Disconnect plug connections (1) and (2).
Detach hose (3) in direction of arrow.
Release screws (4) and remove rear window wiper motor (5).
Installation:
Insert screws (4) and tighten until hand-tight.
Center rear window wiper motor (5) and tighten down
screws (4).
Observe tightening torque, 61 62 8AZ.
Adjusting spray nozzle on rear window washer unit.
Installation:
Replace rubber grommet (1).
Pay attention to installation position of rubber grommet (1).
Marking must point to tip of arrow.
RA Removing and installing / replacing rear window wiper motor
BMW AG - TIS
26.01.2013 21:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
