3 Series E46 318Ci (M43TU) COUPE
Mark out measurements for both bores on instrument panel
support tube.
Side measurement of lower bore:
Measurement (D) = 11.0 mm from edge of sheet metal into which
both bores are drilled.
Side measurement of upper bore:
Measurement (D) = 10.5 mm from edge of sheet metal into which
both bores are drilled.
Note:
Make sure that in the area of the marked bores there are no leads
or other items of equipment which can be damaged.
If necessary, remove or protect existing components.
Draw off swarf when drilling.
Drill two 8.5 mm dia. bores (1, 2) at the marked points in the
instrument panel support tube.
Deburr bores and protect against rust.
Note:
A bracket (1) for the instrument panel trim is spot-welded to the
instrument panel support tube on LHD vehicles on the right (in
direction of travel) and on RHD vehicles on the left (in direction of
travel).
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
30.01.2013 10:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
