3 Series E46 318Ci (N46) COUPE
Installation:
Fit support sleeve (4) with radial seal (1) on crankshaft.
Align groove (2) centrally to housing partition (3).
Coat both grooves (2) on radial seal (1) with Loctite primer,
manufacturer's number 171000, and expose to air for approx.
one minute.
Push radial seal (1) by hand as far as possible onto running
surface.
Carefully remove support sleeve (4).
Screw special tool 11 9 182 with screws (special tool
11 9 184 ) to crankshaft.
Draw in radial seal with special tool 11 9 181 in conjunction
with special tool 11 9 183 until flush.
Before filling with sealing compound:
Insert brush with Loctite primer, manufacturer's number 128357,
as far as possible into grooves (1) on radial seal and coat
housing partition on engine block.
RA Replacing crankshaft radial seal (N40/N42/N45/N46)
BMW AG - TIS
07.02.2013 14:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -