3 Series E46 318Ci (N46) COUPE
Place special tool 11 9 292 on inlet camshaft and align inlet
camshaft so that special tool 11 9 292 rests without a gap on
cylinder head.
Place special tool 11 9 291 on exhaust camshaft.
Turn back special tool 11 9 293 .
Hold inlet camshaft with special tool 11 9 291 so that it rests
without a gap on cylinder head.
Insert screws and tighten down special tool 11 9 291 on
cylinder head.
Tighten down special tool 11 9 293 by hand until it is supported
on special tool 11 9 292 .
Insert screw and tighten down special tool 11 9 292 on cylinder
head.
RA Removing and installing/replacing inlet and exhaust adjustment unit (N42/N46)
BMW AG - TIS
07.02.2013 14:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -