3 Series E46 318Ci (N46) COUPE
Release oxygen sensor with special tools 11 7 030 and
11 9 150 and remove.
Tightening torque, 11 78 1AZ .
Support transmission with a workshop hoist.
Release screws and remove cross-member (1).
Tightening torque, 23 71 1AZ / 2AZ
.
Release screws.
Tightening torque, 26 11 1AZ .
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque, 26 11 6AZ .
Bend propeller shaft downwards at center bearing.
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
RA Removing and installing transmission (S5D 200/250G, N42/N45/46)
BMW AG - TIS
07.02.2013 16:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -