3 Series E46 318Ci (N46) COUPE
Lower transmission until cylinder head touches bulkhead.
Attach special tool 11 8 022 to left and right control arms (1).
Tighten down knurled screws until special tool 11 8 022 rests
against engine oil sump (2).
Important!
Position special tool 11 8 022 in such a way that engine oil
sump (2) rests safely on special tool 11 8 022 .
Do not damage oil level sensor.
Important!
Slowly relieve tension on clutch slave cylinder during removal
as otherwise air will be drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder. Pressure line
remains connected.
Tightening torque, 21 52 5AZ .
Detach locking clamp.
Pull shift rod (1) out of shift rod joint (2).
Remove washers (3).
Installation:
Grease shift rod pin (4).
Grease,
Refer to BMW Service Operating Fluids.
Large contact surface of disks (3) must rest on shift rod joint
(2).
RA Removing and installing transmission (S5D 200/250G, N42/N45/46)
BMW AG - TIS
07.02.2013 16:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -