3 Series E46 318Ci (N46) COUPE
Remove bushing (1).
Press crash disk (3) off crash sleeve (2).
Lift crash sleeve (2) out of groove of steering shaft and remove.
Remove crash disk (3).
Installation:
Replace bushing (1) and crash sleeve (2).
Unfasten nut.
Withdraw operating lever.
Installation:
1.
Washer
2.
Axial needle bearing, grease needles if necessary.
3.
Always replace self-locking nut.
-
Fit disk (1), needle bearing (2) and new nut (3).
-
Move adjusting lever into locked position.
-
Screw on nut (3) until contact is made with needle
bearing (2).
-
Open and close adjusting lever.
-
Tighten nut (3) to torque value 1.
Tightening torque: 32 31 3AZ
.
-
Open and close adjusting lever again.
-
Tighten nut (3) to torque value 2.
Tightening torque: 32 31 3AZ
.
-
Open and close adjusting lever again.
-
Tighten nut (3) again to torque value 2.
Tightening torque: 32 31 3AZ
.
Observe tightening torque without fail; the actuating force of the
operating lever is adjusted by means of the tightening torque.
RA Disassembling and assembling steering column
BMW AG - TIS
07.02.2013 18:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -