3 Series E46 318Ci (N46) COUPE
Remove screws (1).
Remove vane pump (2) from water pump (3) and remove
towards bottom/top.
Installation:
Replace O-ring on water pump connecting piece and coat with
coolant.
Align vane pump shaft (2) to mounting on water pump (3).
Important!
Make sure connector is correctly seated in crankcase.
Connector must not jam when inserted!
After installation:
•
Add coolant and hydraulic fluid
•
Venting cooling system and checking for water leaks
•
Bleeding hydraulic system
•
Check pipe connections for leaks
RA Removing and installing/replacing power steering vane pump (N4x)
BMW AG - TIS
07.02.2013 18:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -