3 Series E46 318Ci (N46) COUPE
Open cable holder (1).
Pull cable out of fixtures on trailing arm.
Cable routing up to 03/02:
Open cable holders (1). Pull cable (2) out of fasteners on rear
swinging fork.
Important!
If a trailing arm is replaced and there is no bore hole for the
holders, it is necessary to lay the cable as in vehicles from
03/02 through the trailing arm.
Cable routing from 03/02:
Open cable holder (1).
Feed cable out of fixtures and through trailing arm (2).
Release hexagon socket screw (1). Withdraw wheel speed
sensor (2) from bore hole.
Installation:
Clean bore hole for pulse generator and grease with
Staburags NBU 12/K lubricating grease (refer to BMW
Service Operating Fluids).
Tightening torque, 34 51 6AZ .
RA Replacing a rear pulse generator
BMW AG - TIS
07.02.2013 19:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -