3 Series E46 318Ci (N46) COUPE
41 00 ...
Arranging shaped parts for cavity bulkhead
To reduce interior noise, certain areas of the body can have the cavities sealed. To do this, shaped parts are inserted
in the cavities. The shaped parts expand to fit the contact faces perfectly by heating the body to approx. 180
°
C and
holding the temperature for approx. 20 minutes.
Since it is not possible during body repairs to heat the body up and maintain it at temperature for long enough, the
following procedure has been defined for this eventuality.
This procedure is described in
Installation of shaped parts for cavity bulkheads, except for side member cover
Installing cavity bulkhead cover for side member
Installation of a cavity bulkhead with cavity foam
.
Location of shaped parts for cavity bulkhead in E46 Coupé
Location of shaped parts is marked by points.
-
(1) A-pillar,
refer to 41 00 ...
Installation of a cavity bulkhead with cavity foam
Installing shaped parts for cavity bulkheads, except for cover for side member
-
(2) Side cowl panel, inside and outside,
refer to 41 00 ...
Installing shaped parts for cavity bulkheads, except for cover for side member
RA Arranging shaped parts for cavity bulkhead
BMW AG - TIS
07.02.2013 20:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -