bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 SI BMW Emblem Comes Loose From Fresh Air Intake Hood E46 M47|Page 199 > < 4 SI Dent Repairs Without Damaging Paintwork All Models
Page 1
background image

VS-21/Löschan

Baugruppe/Group: 13

13 02 99 (445)

weltweit
all countries

07/1999

BMW emblem comes loose from fresh air intake hood

E46 / M47

Complaint: 

On the vehicles mentioned above, it is possible for the BMW emblem to come loose from
the fresh air intake hood. Attempts to refit the BMW emblem using commercially available
glues will not be successful due to the lack of adhesion of the BMW emblem.

Cause: 

Silicon residue on the BMW emblem from production prevent reliable cementing.

Affected
vehicles:

E46 with M47 
Manufacturing period: start of series production up to September 1999

Remedy: 

The manufacturing processes will be revised from September 1999 to prevent the above
complaint from occurring. 
In case of customer complaint, the loose emblem is to be replaced with a new emblem
employing special adhesive tape, or the fresh air intake hood is to be replaced.

Procedure:

Loosen the adhesive foil from the BMW emblem and attach the emblem to the fresh air
intake hood at the place proved using the old glue. 
However, this is only permissible if the area of the old glue is about 35 mm.

The cementing surface must be clean of grease and dust.

If there are only two adhesives beads remaining of the old glue, the fresh air intake hood
must be replaced. It is not advisable to glue on a new emblem as the available cementing
surface is too small to provide for adequate adhesion.

Parts: 

Description

Part number

BMW emblem with adhesive tape

Part no. 13 71 7 785 999

Fresh air intake hood 
(intake snorkel)

Part no. 13 71 2 247 408

Reimbursement: 

Material and labour costs incurred can be claimed through the usual warranty channels
subject to current warranty terms as follows:

Defect code

13 71 91 37 00
The defect code is not contained in the official
defect code catalogue but has been included in
the system, thus enabling warranty claims to be
processed.

Fit BMW emblem:

Job number

00 52 251

Labour

1 FRU

Replace fresh air intake hood:

Job number

00 52 252

Labour

3 FRUs

Warranty type

1

Warranty stage

1 (within vehicle warranty)
2 (outside vehicle warranty)

SI  BMW emblem comes loose from fresh air intake hood E46 M47

BMW AG - TIS

09.02.2013  01:36

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

1 SI BMW Emblem Comes Loose From Fresh Air Intake Hood E46 M47|Page 199 > < 4 SI Dent Repairs Without Damaging Paintwork All Models