3 Series E46 318d (M47) SAL
The plug (1) must be released so that the static basic setting can
be measured.
Installation:
Replace sealing ring.
Tightening Torque of plug (1),
refer to Technical Data 13 51 12AZ.
Note:
The setting value of the injection pump is stamped next to the
nameplate.
The fuel return line (1) covers the injection pump nameplate.
Remove fuel return line (1).
Installation:
Replace sealing ring.
Tightening torque of fuel return line (1),
refer to Technical Data 13 51 11AZ.
Screw in special tool 13 5 200 and tighten down by hand.
Install special tool 00 2 510 (dial gauge) and secure to
approx. 5 mm preload.
Lift timing chain and hold under tension.
Rotate engine at central bolt 90
°
against direction of rotation.
Set scale of dial gauge to zero.
Crank engine at central bolt in direction of rotation until piston of
first cylinder is in "TDC position".
Locate flywheel in TDC position with special tool 11 2 300.
RA Removing and installing cylinder head (M47)
BMW AG - TIS
09.02.2013 03:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
