3 Series E46 318d (M47) SAL
Detach vacuum hose (1) to EGR valve and (2) to distributor in
hose to vacuum pump at pressure converter for EGR valve.
Release screws (3) and remove pressure converter for EGR
valve.
Release screws (1) on injection pump.
Release screws (2) on engine block and remove injection pump
support (3).
Detach leakage oil hose (1).
Release banjo bolts (2). Remove hydraulic lines.
Installation:
Replace leakage oil hose.
Replace seals.
Tightening torque,
refer to Technical Data 13 51 10AZ.
Refer to Technical Data 13 51 11AZ.
Unfasten drain plug.
Installation:
Check O-ring, replace if necessary.
Tightening torque,
refer to Technical Data 11 14 3AZ.
RA Removing and installing/replacing injection pump (M47)
BMW AG - TIS
09.02.2013 04:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -