3 Series E46 318d (M47) SAL
Open oil filler neck.
Crank engine in direction of rotation until cast lug (1) on inlet
camshaft points upwards.
Note:
Cast lug (1) on inlet camshaft points upwards at firing TDC,
cylinder 1.
Lay special tool 11 2 300 (plug mandrel) parallel to speed
sensor (1) on reinforcing rib of engine and allow it to snap into
place audibly at firing TDC, cylinder 1.
Caution!
The injection pump shaft may rotate if it is not blocked by the
blocking screw.
The reference for installing the pump will thus be lost and will
have to be statically readjusted,
refer to 13 51 005.
Release locking screw (1) on injection pump.
Remove spacer (2) and tighten down locking screw (1). The
pump shaft is thus blocked.
Tightening torque,
refer to Technical Data 13 51 14AZ.
RA Removing and installing/replacing injection pump (M47)
BMW AG - TIS
09.02.2013 04:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
