3 Series E46 318d (M47TU) SAL
Lift engine hood into assembly position.
Note:
The following work must be carried out with a second person
assisting. Work instruction applies to left and right sides.
Gently raise retaining clip and simultaneously push upwards.
Hold engine hood, unhook damper on hood.
Slide special tool 51 2 160 over damper.
Open engine hood completely.
Reconnect damper to engine hood with special tool 51 2 160 .
Drain and dispose of coolant.
Installation:
Replace seal.
Tightening torque, 11 11 5AZ .
Vent cooling system and check for leaks.
Installation:
Refer to general instructions for work on cooling system.
Remove fan cowl.(Manual)
Remove radiator blind.(Automatic)
RA Removing and installing engine (M47TU)
BMW AG - TIS
11.02.2013 13:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
