3 Series E46 318d (M47TU) SAL
Remove plug from special tool bore.
Crank engine from 45
°
before TDC position in direction of rotation
up to TDC firing position.
Secure crankshaft with special tool 11 2 300 in TDC position.
Caution!
Remove special tool 11 2 300 before starting engine.
Align inlet camshaft and secure with special tool 11 6 320 in
firing TDC position of first cylinder. Fit gear wheel of inlet
camshaft.
Installation:
Bearing pins must be replaced.
Tightening torque, 11 31 12AZ
.
Installation:
Replace camshaft screw (3).
Insert guide rail (2).
Screw down screw pins on guide rails.
Fit sprocket wheel with timing chain.
Insert camshaft screw (3), tighten by hand and then release
again by half a turn.
Note:
The position of the sprocket wheel to the camshaft does not
influence the function in any way.
Install gear wheel and bushing of exhaust camshaft (7).
Installation:
Replace camshaft screw (6) and tighten by hand.
RA Replacing camshafts (M47TU)
BMW AG - TIS
11.02.2013 13:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -