3 Series E46 318d (M47TU) SAL
Note:
Two covered removal holes (1) are located on the end face of
the radial sealing ring.
Screw special tool 23 0 490 into one of the two removal holes.
Withdraw radial seal from transmission housing with aid of impact
weight.
Attach special tool 23 0 182 to transmission input shaft.
Coat sealing lips of new radial seal (1) with gear oil and push on
up to transmission housing.
Remove special tool 23 0 182 from transmission input shaft.
Drive in radial seal with special tools 23 0 181 and 23 2 491
as far as it will go.
Note:
To drive in: use a plastic hammer.
RA Replacing radial seal for drive shaft (GS5-39DZ)
BMW AG - TIS
11.02.2013 15:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
