3 Series E46 318d (M47TU) SAL
Important!
Do not let propeller shaft fall into joints. In particular, on the
constant velocity joint, the rubber sleeve gets squashed or the
joint is damaged.
Grip propeller shaft and release nuts.
Tightening torque 26 11 6AZ .
Installation:
Pull off cover tape from butylene tape on both sides.
Stick butylene tape (1) to outside of center bearing (2).
Butylene tape,
refer to BMW Parts Service.
Important!
Remove butylene tape already attached to center bearing.
Clean adhesive area on center bearing and on body.
Then coat adhesive area on body with mineral oil.
This coating with oil is necessary to facilitate insertion of the
sticky butylene tape in the propeller shaft tunnel.
This prevents the butylene tape from being deformed.
RA Removing and installing propeller shaft - version with rear constant-velocity jo
BMW AG - TIS
11.02.2013 15:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
