3 Series E46 318d (M47TU) TOUR
Raise intake pipe (1) a little.
Unclip lines (2) from upper bracket.
Detach hose (3) on air cleaner housing.
Unclip lines (1) from lower bracket.
Detach hose (2).
Remove intake pipe (3).
Installation:
Apply a thin coat of petroleum jelly to sealing surfaces of
sealing rings (1).
Insert sealing rings (1) in intake snorkel.
Disconnect plug connection (2) on air-mass flow sensor.
Release screws (1).
Remove air-mass flow sensor.
Tightening torque, 13 62 7AZ.
Read out fault memory of DDE control unit.
Check stored fault messages.
Rectify fault and clear fault memory.
RA Removing and installing/replacing air-mass flow sensor (M47TU)
BMW AG - TIS
11.02.2013 14:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
