3 Series E46 318d (M47TU) TOUR
A5S 360R (GM5) transmission:
Pull out seals (1), (2) and (3).
Coat new seals with automatic transmission fluid and install.
A4S 360R (GM4) transmission:
Pull out seals (2) and (3).
Coat new seals with automatic transmission fluid and install.
Caution!
A4S 360R (GM4) transmission without seal (1).
Installation:
Blow out tapped holes with compressed air gun.
Insert both supplied set screws (1) into tapped holes.
Length of screws:
(1) = (2) = 68 mm, all others = 50 mm.
Install shift unit with aid of both set screws and secure in place
with screws.
Remove both set screws. Tighten all screws until it is hand-tight.
When tightening screws:
follow sequence without fail.
Tightening torque, 24 30 1AZ .
Do not tighten screws (1) and (2) yet.
Suspend guide (1) of transmission switch in detent spring (2).
Important!
Journal (3) of detent disk must be located in groove (4) of
slide valve.
RA Removing and installing/replacing selector unit (A5S 360R/390R, A4S 200R)
BMW AG - TIS
11.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -